RESOLUTION NO. 28

Pursuant to Section 3 of Republic Act No. 318, known as the Chemical
Engineering Law of the Philippines and Section 6 of PD No. 223, as
amended, the Board of Chemical Engineering hereby adopts the following
Guidelines for the Continuing Professional Education (CPE) Program for
registered Chemical Engineers of the Philippines as recommended by the
Philippine Institute of Chemical Engineers (PICHE) after consultation
with the Board.

I
Rationale

Continuing Professional Education program for Chemical Engineers
(CPE-CHE) refers to education and training acquired after getting the
license to practice chemical engineering in the Philippines.  It aims to
update the professional skill and advanced knowledge of chemical
engineers.  This is in keeping with the engineer’s sacred duty and
responsibility to render optimum service to his employer/client, in
particular, and the public in general, throughout his professional
life.  It is therefore the obligation of a chemical engineer to be
continuously involved in CPE activities.

The CPE-CHE activities include both formal academic pursuits and
degrees and the less structured, non-academic activities and programs on
technical areas such as process or equipment design, industrial plant
installation and operation, systems and energy management, computers,
engineering education and other related areas.

II
The CPE-CHE Accreditation

To ensure that practicing professional chemical engineers keep up
with their profession through continuing professional education, an
accreditation and monitoring system has to be set-up and implemented.

A. Responsibility — Since the Philippine Institute of
Chemical Engineers (PICHE) is the accredited organization for the
chemical engineering profession, it is therefore tasked with the
following responsibilities for the attainment of an effective CPE
program.

1.       The creation of the National Accreditation Committee on Continuing Professional Education for Chemical Engineers.

2.       Dissemination of information to practitioners of policies governing accreditation of the CPE activities.

3.       Initiation of programs of activities that will provide
opportunities for practitioners to earn units for accreditation in the
CPE-CHE.

4.       Support the Board of Chemical Engineering in monitoring
the number of units earned by the members in preparation for the renewal
of the professional ID card.

B. Criteria — In order to earn units for CPE accreditation, the following requirements shall be satisfied.

1.       Topics shall be related to chemical engineering and/or its allied fileds.

2.       The scope shall be beyond that of the basic preparation for a baccalaureate degree in chemical engineering.

C. Requirement — A total of twelve (12) credit units per
annum or an accumulated thirty-six (36) credit units for three (3) years
for the renewal of the professional ID card for the practice chemical
engineering.

Records of credit units for CPE shall be kept by the Accreditation
Committee on an annual basis from January 1 to December 31 of each year
and accumulated over a period of three (3) years.  Units earned excess
of requirement within the specific period may not be carried over to the
next renewal period.  However, for every thirty (30) excess accumulated
units at the time of renewal of license, the license issued shall bear a
star of recognition for the practitioner.

III
The National Accreditation Committee

The Committee shall be composed of a Chairman and four (4) members of
the PICHE and a member of the Board of Chemical Engineers acting as
consultant.

The members of the Committee shall be appointed by the President of
the PICHE for a minimum of three (3) years.  The appointee must have at
least ten (10) years of professional practice.

The Committee functions shall include:

1.       Formulate program guidelines for continuing professional education for chemical engineers.

2.       Evaluate programs/activities for accreditation.

3.       Accredit programs/activities upon request of the PICHE.

4.       Accredit seminars, workshops, local conferences, etc.
for continuing professional education upon the request of PICHE
Chapters.

5.       Monitor and periodically assess program implementation.

6.       Review and revise guidelines at least every three (3) years or as arises.

The Committee shall meet every quarter at such time and place to be
determined by the Chairman.  Special meetings may be called by the
Chairman or upon the request of members who have served the Committee
for at least two (2) years.

IV
Accredited Programs and Activities and Corresponding Units

The programs and activities that may be accredited for CPE.

A.  ACADEMIC PROGRAMS
1.  M.Sc. in Chem. Eng’g.       Ph.D. in Chem. Eng’g. Note: To be availed of only once. 2.  For every nine (9) academic units earned towards M.Sc. Ch.E.       For every six(6) academic units towards Ph.D.	36 units 36 units   15 units 15 units
B. TECHNICAL LECTURES AND SEMINARS
1.  As lecturer/resource speaker 2.  As participant Note: Not to exceed 12 units per lecture or seminar.	6 units/session 2 units/session
C.  WORKSHOPS
1.  As moderator 2.  As participant Note:  Not to exceed 12 units per workshop.	4 units/session 2 units/session
D. PICHE NATIONAL/CHAPTER CONVENTION
As delegate Plus: As speaker        As moderator/reactor	9 units 6 units 4 units
E. OTHER LOCAL TECHNOLOGICAL/ PROFESSIONAL CONVENTION
As delegate Plus: As speaker      As moderator/reactor	9 units 6 units 4 units
F.INTERNATIONAL TECHNOLOGICAL/PROFESSIONAL CONVENTION
1.  As delegate and speaker 2.  As delegate	24 units 12 units
G.        AUTHORSHIP
1.       Book      a.  As single author-      b.  As co-author- 2.  Technical Paper/ Articles (published)      a.  Single authorship-      b.  Major author      c.  Junior author 3.  Instructional Materials      a.  Adopted by technical school      b.  In-campus use      c.  Laboratory manuals adopted by technical schools      d.  Laboratory manuals adopted by for in-campus use only      e.  Study guides self-instructional materials, cassette/video tapes	36 units 18 units 15 units 9 units 6 units   15 units 10 units 12 units 8 units 6 units
H.         PARTICIPATION IN PICHE ACTIVITIES
1.  As National Chapter/Officer 2.  As Chairman of PICHE National/ Chapter standing or ad hoc Committee 3.  As member of PICHE National/ Chapter Committee 4.  As member of PICHE National Chapter	12 units 8 units 3 units 3 units
I.          EMPLOYMENT
1.   Employed as chemical engineer of in chemical engineering related work For one full year duly certified by employer 2.   Self Employed in a venture involving chemical engineering know how       For one full year duly certified by PICHE 3.   Professor, lecturer or instructor handling professional chemical engineering, science or mathematics subjects       For every subject unit per semester/ trimester duly certified by the school	6 units 6 units     2 units
J.         RESEARCH
1.   Invention patented 2.   Innovation recognized by DOST 3.   Creative Research completed and recognized by DOST	36 units 12 units 9 units
K.        AWARDS AND RECOGNITION
1.   Awards or recognition given by PICHE National/Chapter 2.   Awards or recognition given by National Government 3.   Awards or recognition given by Local Government 4.   Awards or recognition given by Civic Organization 5.   International award/recognition as Ch.E.	12 units 18 units 9 units 4 units 36 units
L.         OTHER RELATED TECHNICAL ACTIVITIES SUBJECT TO APPLICATION BY CONCERNED PARTY AND APPROVAL BY ACCREDITATION COMMITTEE	6 units

V
Exemptions

1.  A registered chemical engineer shall be exempted from
complying with the CPE upon reaching the age of sixty-five (65) years.

2.  Practicing chemical engineers who are outside the country upon presentation of proof/document.

The Board, therefore resolved, as it hereby resolves, that upon
approval of this resolution and after fifteen days following its
publication in the Official Gazette starting January, 1991, a Chemical
Engineer will be required to submit 12 credit units every year or a
total of 36 units  for 3 years for renewal of her/his professional I.D.
card.

VI
Effectivity

These rules shall become effective upon approval by the Commission
and after fifteen (15) days following its publication in the Official
Gazette.

Adopted: 3 May 1990

(SGD.) ALBERTO S. MUYOT Chairman
(SGD.) LYDIA G. TANSINSIN Member	(SGD.) ZINNIA P. TERU Member

 Approved:

(SGD.) JULIO B. FRANCIA, JR. Commissioner
(SGD.) NILO C. MARIANO Associate Commissioner	(SGD.) MARIANO A. MENDIETA Associate Commissioner